|
|
The first picture is a surprise because you are looking at the tank sender hole minus the previously installed sender! When connecting the wire loom to the sender, the screw just kept turning without any real torque on it. Clearly it had broken during tightening so I removed it. The black wire in the last picture had come off the center stud. It was an easy fix to resolder it so I did. I whipped up a batch of preseal and applied it to the sender. I potted the whole lower part of the assembly in preseal just in case the looseness of the stud would leak. Then I put it back and tested it and it worked fine.
|
