As seen in my prior post, the project is starting to get to the end. A lot has happened, or should I say, a lot has arrived!

I’ll get to the meaning of that later. From where I left off, it was time to fit the rear window. The piece came in the finishing kit and required very little trimming. In the first picture you get it in place and then mark two slots that need to be cut to allow the window to slide back far enough, as shown in the second picture.

When that is done, you can start drilling the holes in the window where it will attach.  Kathy is holding a wood block behind where the holes need to be drilled to help keep the window from cracking.