Click a photo to embiggen

Yeah! Done with the panel.

Time to move on to the landing gear. I’ve been working on the airplane while it sits on the table I made from the fuselage kit crate. It is not possible to put the legs on because the table is too low and blocks access to the fuselage floor where the gear legs go. I had to lift up the fuselage and put it on supports a couple of inches higher.

To do that, I used my new shop crane to lift the fuselage and put the supports under it. It took some rearranging as the supports were holding up a temp table with the canopy on it. I moved things around and now I could work on the gear.