After all the switches and wire bundles were finished and tied up it was time to turn everything on. After some minor bug chasing it all works.
The last two pictures show a change I made prior to the next step, which was installing the engine control cables. I noticed that my memory of how the cables routed was incorrect. I had not left enough space in one of the firewall penetrations to allow for engine wiring and controls. I decided to reroute the CHT and EGT leads out of a different firewall penetration. Picture three shows them coming out of the new location. Picture four shows a plate I made that attaches to the center rudder pedal support. The support had two lightening holes already, one too big and one too small, so I just made a plate to cover the big hole and put a grommet through it and then routed the wires that way.
