The sealant can also be purchased in a tube. I had bought one earlier and it was about to expire so I decided to use it up by installing both othe the final ribs in one go. The tube has the same two hour working time and it fits in the gun I bought for it. It worked very well but I liked being able to mix a specific amount and the syringe was just as good. If I was to do it again I don’t think I would use the tubes. They are nice but my setup worked very well.
The last rib is in place in the last picture and it also has the fuel level sender installed. You do one dry install to git the float wire then you install it with sealant.
