To the Airport!

The first picture shows the T handle for the canopy release installed. Since I won’t be doing aerobatics most of the time, I wanted a way to safe it so that the handle can’t be pulled in flight to release the canopy. I made the little bracket and drilled a bolt hole through the rod to secure it. If I get in the plane with a parachute, it will be part of the aerobatic checklist to remove the bolt.

Picture two shows a little clip I made to route GPS antenna wires from the glare shield to there devices. The molex connector is for all the electrical wires that run to the canopy.

Picture three shows the wire bundle that will route from the canopy to the panel.